maximum autohrozed total mass 最大設計裝載質量
maximum design pay mass 最大允許裝載質量
maximum autohorized pay mass 廠定最大總質量
manufacturer's maxumum total mass 載重量
payload 車輛自重
kerb weight 總重量
gross weight 軸荷
axle load 最大設計軸荷
maximum design axle load 最小設計軸荷
minimum authorized axle load 最大允許軸荷
maximum design axle load 輪胎最大設計拖掛質量
maximum design tyre load 最大設計拖掛質量
maximum authorized tyre load 最大允許拖掛質量
maximum authorized towed mass 汽車列車最大設計質量
maximum design mass of vehicle combination 汽車列車最大允許質量
maximum authorized mass of vehicle combination 鉸接車最大設計質量
maximum disgn mass of articulated vehicle 鉸接車最大允許質量
maximum authorized amss of articulated vehicle 半掛牽引車承受的最大靜載荷
maximum design static laod borne by semi-trailer towing vehicle 作用在掛接裝置上的最大設計靜載荷
maximum design static laod on coupling device 作用在掛接裝置上的最大允許靜載荷
maximum authorized static load on coupling device 比功率
power/mass ratio 比扭矩
torque/maximum total mass ratio 重量利用系數
factor of weight utilizaton 汽車型譜
chart of automotive model 后驅動汽車
rear drive automobile 前驅動汽車
front drive automobile 發動機后置式客車
bus with rear engine 四輪驅動車輛
all wheel drive automobile 發動機前置式客車
bus with front engine 發動機底置式客車
bus with underfloor engine 計算機輔助設計
computer aided deisgn(cad) 有限壽命設計
design for finite life 累積疲勞損傷原理
theory of cumulative damage in fatique 優化設計
optimum deisgn 汽車尺寸控制圖
sketch on layout ofr dimenshion's control of assembly 汽車總裝配圖
automobile assembly drawing 汽車總布置草圖
sketch for automobile layout 汽車設計的技術經濟分析
technical -economic analysis in automobile design 設計任務書
design assignment 系列化、通用化、標準化
seriation ,universalization and standardization 總布置設計
calculation for layout 運動校核
correction of motion 側視輪廓
side outline 前視輪廓
end outline 頂視輪廓
plan outline 車長
vehicle length 車寬
vehicle width 車高
vehicle height 軸距
wheel base 輪距
track 前輪距
track front 后輪距
track rear 雙胎間距
space between twin wheels 前懸
front overhang 后懸
rear overhang 離地間隙
ground clearance 縱向通過角
ramp angle 接近角
approach angle 離出角
departure angle 車架高度
height of chassis above ground 駕駛室后車架最大可用長度
maximum usable length of chassis behind cab 車身長度
body work length 車廂內部最大尺寸
maximum internal dimension of body 貨廂內長
loading space length 貨廂有效長度
loading length 貨廂內寬
loading space width 貨廂有效內寬
loading width 貨廂內高
loading space height 貨廂有效內高
loading height 貨臺高度
loading surface height 車架自由長度
frame free length 欄板內高
inside board hegiht 貨廂容積
loading surface 門高
door height 門寬
door width 車架有效長度
chassis frame useful length 貨廂全長
body length 牽引桿長
drawbar length 牽引裝置的位置
position of towing attachment 牽引裝置的懸伸
overhang of towing atachment 牽引裝置的高度
heigth of towing attachment 牽引裝置牽距
distance of towing attachment 牽引座前置距
fifth wheel lead 長度計算用牽引座前置距
fifth wheel lead for calculation of length 質量分配用牽引座前置距
fith wheel lead for calculation of mass distribution 牽引座結合面高度
height of coupling face 牽引裝置至車輛前端的距離
distance between towing device and front end of towing vehicle 牽引叉銷至車輛前端的距離
distance between jaw and front end of towing vehicle 半掛車間隙半徑
rear tractor clearance radius of semi-trailer 半掛車前回轉半徑
front fitting radius of semi trailer 車輪垂直行程
vertical clearance of wheel 車輪提升高度
lift of wheel 轉彎半徑
turning circle 靜止半徑
static radius 碰撞
collision (crash,impact) 正碰撞
frontal collision (frontal impact) 側碰撞
side collision (side impact) 后碰撞
rear collision (rear impact) 擦碰撞
sidewipe collision 碰撞方向
collision direction 碰撞角度
collision angle 傾斜的
oblique(tilt) 成角度的
angled 縱向的
longitudinal 垂直的